لإصلاح الغسالات في دبي

كمال رامي

New member
3 مايو 2018
Al Quoz Third Dubai Washing Machine Repair

[FONT=Times New Roman, serif]A Complete Guide to Repair Washing Machine PCB[/FONT]
[FONT=Times New Roman, serif]Steps to Repair Washing Machine PCB[/FONT]
[FONT=Times New Roman, serif]Let'a give you the step by step instructions on it![/FONT]

  1. [FONT=Times New Roman, serif]It is to be mentioned that in the starting the front loader washer must be empty before you can open the door to work on it. You need to make sure all screws and components are tight. For the information of the readers, we would like to mention that washing machine is all known as the big tub that repeatedly fills with water and then drains. It does spins to wring clothes dry. It also accompanies the device for stirring the contents up that is either an agitator in the middle of a top-load machine or a rolling drum in a front-loading machine.[/FONT]
  2. [FONT=Times New Roman, serif]After it, the four cycles in the washing machine will be performing the task of the fill, wash, drain, and spin. These functions are basic in any washing machine so there are a few numbers of things can go wrong with them. [/FONT][FONT=Times New Roman, serif]Al Quoz Third Dubai Washing Machine Repair[/FONT]
  3. [FONT=Times New Roman, serif]If the washer does not operate or make any noise when set on any cycle, then it is possible that it is not receiving electrical power.[/FONT]
  4. [FONT=Times New Roman, serif]If the washing machine stopped at the time when it has to be continued on to the next cycle, then the machine's overload protector may have tripped. You have to out some of the articles to reduce the load and let the protector reset itself. After it, you can restart the machine.[/FONT]
  5. [FONT=Times New Roman, serif]You have to make sure the machine is plugged in and turned on. If not, then you have to check the receptacle as it has to be plugged into for power. This can be all done as by using a working lamp, or the appliance, or voltage tester. You do need to make sure that the washer lid is closed completely.[/FONT]
  6. [FONT=Times New Roman, serif]If in the condition the receptacle seems dead, then you should check the circuit breaker or the fuse that serves it.[/FONT]
  7. [FONT=Times New Roman, serif]You should also check the power cord. You have to unplug the washer and then check its cord as in favor of the break or frayed area. If you do find it important then you can replace the cord. [/FONT][FONT=Times New Roman, serif]Al Karama Dubai Washing Machine Repair[/FONT]
  8. [FONT=Times New Roman, serif]You have to open with the lid and then check the lid switch and the tab on the lid that it pushes as against. You have to press and release the switch. If still, it is not working then it means that it has been broken. You should remove the switch, test it, and replace it if needed.[/FONT]
  9. [FONT=Times New Roman, serif]If the washer still does not work, the controls may be the fault in it. You should take help from the appliance repair person.[/FONT]

[FONT=Times New Roman, serif]If you want to prevent some of the problems of the washing machine, then you should follow up with some of the best maintenance procedures.[/FONT]
[FONT=Times New Roman, serif]You should make the use of the right amount of detergent for your washer and your water hardness. You do need to make sure the machine is level, and don't overload it.[/FONT]


[FONT=Times New Roman, serif]What to do if Washing Machine Does Not Rinse Correctly?[/FONT]
[FONT=Times New Roman, serif]If there is some residue that is on your clothes or in the washing machine following a cycle, then this can be because of so many reasons. First of all, you have to make sure that you are using the machine properly.[/FONT]
[FONT=Times New Roman, serif]You should be putting the right amount of soap in the load and not be overloading the machine. This is for the reason that the overly bulky load can cause improper rinsing.[/FONT]
[FONT=Times New Roman, serif]If these types of issues are not leading to any problem, then there are chances that the water is not getting into the drum or is not draining out properly. You should be checking the supply valves. [/FONT][FONT=Times New Roman, serif]Al Qusais First Dubai Washing Machine Repair[/FONT]
[FONT=Times New Roman, serif]You should make sure the water supply valves that serve the supply hoses are open all the way. You should also make sure that the supply hoses are not kinked.[/FONT]
[FONT=Times New Roman, serif]You can also give a check on the drain hose to make sure the machine is draining fully.[/FONT]